CONTACT US

X-ray News

The Best – and Worse – BGA Assembly. Ever.

Short (bridges)

Opens

Head-In-Pillow

Planarity

Solder Splatter

You may have moisture in your solder paste which is causing the solder balls to explode off during reflow. This can happen if the paste is refrigerated and not allowed to get to room temperature before opening causing moisture to condense on the paste.

There are a number of factors that can cause solder balls or solder splatter. Moisture being one which you have eliminated by baking. I recommend verifying your under stencil cleaning process to make sure the stencil is not depositing solder paste randomly around the board. Also, make sure your preheat (ramp-up) is slow enough to allow solvent to vaporize and out gas gradually.

You may also want to see if this is occurring on all PCB types or just this one. If you run multiple products, you can narrow your variables down by running other products with the same paste and equipment to see if they exhibit the same problem. Good luck, I hope this helps.

Related Posts

“Everyone’s Got a Beard,” and Other Observations with Phil Stoten

Solid content in this week's Fireside Chat with the Xperts with content specialist Phil Stoten.  That's right, Phil Stoten of SCOOP joins David Kruidhof and...

Read More
“Everyone’s Got a Beard,” and Other Observations with Phil Stoten

Small Footprint, Big Impact: TruView™ PC2

Creative Electron's newest parts counter TruView™ PC2 is getting some attention. One question we've been fielding frequently is "how we're you able to make it...

Read More
Small Footprint, Big Impact: TruView™ PC2

Big Boards, No Problem: TruView™ PCB Inspector

Bare board inspection isn't particularly sexy. We do, however,  think some of you be excited by the capabilities of Creative Electron's new TruView™ PCB Inspector. Big...

Read More
Big Boards, No Problem: TruView™ PCB Inspector
Skip to content